This online shop is using cookies to give you the best shopping experience. Thereby for example the session information or language setting are stored on your computer. Without cookies the range of the online shop's functionality is limited.
If you don't agree, please click here.
12 Volt resistor replacement load for the adaptation of light emitting diode (LED) trailer lamps at vehicles with incandescent lamp monitoring. The failure of direction indicators is indicated.
***CAUTION*** LED-ADAPT must be mounted on a metal surface. The connection of any bulb on the direction indicator output is prohibited. The over current protection may cut off not until after several minutes!
Single cable version
LED direction indicator monitoring
Serves the direction indicators with replacement resistors
Conditionally short circuit proof (about 100 cycles)
Operation voltage
12V nominal
Output current
max. 0.4A (direction) (Over current protection time delay 1...2000s!)
Connection
hose line 5x1mm², ins. 6.3mm blade receptacle
Load imitation
2x17W (direction)
Cable length
0.25 m
Temperature range
-40...+75°C
Electrical protection
overcurrent, overtemperature, reverse polarity
Mechanical protection
entirely sealed (IP69K)
Dimensions
120 x 70 x 25mm
Mass
about 350g
Failure monitor LEDs
20mA (direction)
Mounting rule
cooling plate 8dm² (aluminium sheet 1.5mm thickness) or on chassis frame
Briechle Elektronik – Voltage converters for commercial vehicles - Tel. +49-8282-89485-0
Deutsch
English
