This online shop is using cookies to give you the best shopping experience. Thereby for example the session information or language setting are stored on your computer. Without cookies the range of the online shop's functionality is limited. If you don't agree, please click here.
LA 24-7

LA 24-7

Product number: 11201

LED-ADAPT

▪ Operating voltage: 24V nominal
▪ Input: open cable end
▪ Output: open cable end

Weight: 1.68 kg

24 Volt resistor replacement load for the adaptation of light emitting diode (LED) trailer lamps at vehicles with incandescent lamp monitoring. The failure of a LED unit is indicated and the replacement load is turned off. LED-ADAPT must be mounted on a metal surface.

***CAUTION***
The connection of any bulb on the output is prohibited. The over current protection may cut off not until after several minutes!

  • simply connect ahead of LED lamps
  • LED-failure is indicated
  • short circuit is indicated
  • Serves all lines with replacement resistors
  • Input cable 3,5m can be connected directly to the plug
Operation voltage
24V nominal
Output current
0.4A (Over current protection time delay 1...2000s !)
Connection input
Sheathed cable 8x1mm², bare endings
Connection output
Sheathed cable 8x1mm², bare endings
Load imitation
2x17 W (direction), 2x4W (rear lamp), 1x34W (stop light) 1x17W (fog lamp), 1x17W (reversing lamp)
Cable length input
app. 3,5m
Cable length output
app. 1,2m
Temperature range
-40...+75°C
Electrical protection
Overcurrent, overtemperature, reverse polarity
Mechanical protection
entirely sealed
Dimensions
280 x 70 x 25mm without cable outlet
Mass
app. 1680g
Failure monitor LEDs
20mA (direction) 3mA (rear lamp) 8mA (stop light) 8mA (fog lamp) 20mA (reversing lamp)
Mounting rule
cooling plate 8dm² (aluminium sheet 1.5mm thikness) or on chassis frame
Briechle Elektronik – Voltage converters for commercial vehicles - Tel. +49-8282-89485-0